Tribute 2WD L4-2.5L (2009)
2. Install the 2 brake caliper guide pin bolts and the 2 bushing caps.
-
Tighten the bolts to 50 Nm {5.0 kgf-m, 37 ft-lbf}.
3. Install the brake pad anti-rattle spring using the following procedure:
a. Insert the tab of the spring into the brake caliper cavity.
b. Twist the tab into the cavity (LH side in the upper brake caliper cavity, RH side in the lower brake caliper cavity).
NOTE:If present, the 2-tabbed end of the anchor housing spring must be installed first.
4. Rotate the anchor housing spring and position the upper portion onto the anchor plate.
5. Position the lower portion of the anchor housing spring onto the anchor plate.
6. Push down and inward until the upper and lower ends of the anchor housing spring are latched and seated in the brake caliper cavities.
7. Verify that the anchor housing spring is correctly latched by pulling on the spring.
CAUTION:The latch MUST be positioned as shown or damage to the component may occur.
8. Install the brake flexible hose to the brake caliper.
-
Tighten to 20 Nm {2.0 kgf-m, 177 in-lbf}.
NOTE:Make sure that the brake flexible hose is not twisted.
9. Position the brake flexible hose and install a new retainer clip.
