Tribute 2WD L4-2.5L (2009)
Brake Caliper: Service and Repair
Brake Caliper Anchor Plate Removal/Installation
BRAKE CALIPER ANCHOR PLATE REMOVAL/INSTALLATION
1. Remove the wheel and tire assembly. See See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
-
Support the caliper using mechanic's wire.
CAUTION:Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
3. Remove the 2 brake caliper anchor plate bolts.
-
To install, tighten to 175 Nm {17.8 kgf-m, 129 ft-lbf}.
4. Remove the brake caliper anchor plate.
5. To install, reverse the removal procedure.