Tribute 2WD L4-2.5L (2009)
Vehicles with 3.0L engine
1. Disconnect the master cylinder brake tube fittings from the master cylinder and remove the brake tubes.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
All vehicles
1. Disconnect the front brake tube fittings from the HCU.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
NOTE:The brake tubes must be installed in the same location as removed.
2. Disconnect the rear brake tube fittings from the jumper tubes.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
3. Disconnect the electrical connector by rotating the protective cover.
4. Remove the 3 HCU bracket-to-frame bolts and remove the HCU.
-
To install, tighten to 20 Nm {2.0 kgf-m, 177 in-lbf}.
5. To install, reverse the removal procedure.
-
Bleed the brake system. See See: Brake Bleeding/Service and Repair/Brake System Bleeding.