Tribute 2WD L4-2.5L (2009)
2. Remove the jumper tube assembly bracket nut.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
3. Disconnect the jumper tubes fittings from the HCU and remove the jumper tube assembly.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
4. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm {0.2 kgf-m, 18 in-lbf}.
5. To install, reverse the removal procedure.
6. Configure the ABS module. See See: Body and Frame/Body Control Systems/Body Control Module/Description and Operation/Module
Configuration.
7. Calibrate the ABS module. Follow the instructions on the scan tool.
NOTE:Vehicle must be on level ground and at a complete stand still during calibration.