Tribute 2WD L4-2.5L (2009)
Hose/Line HVAC: Service and Repair
Evaporator Outlet Line Removal/Installation
-
EVAPORATOR OUTLET LINE - 2.5L AND 3.0L REMOVAL/INSTALLATION
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Recover the refrigerant. See See: Service and Repair/Discharging And Recovery.
3. Remove the RH lower engine splash shield.
4. Remove the A/C compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
5. Detach the wire harness clip from the evaporator outlet line.