Tribute 2WD L4-2.5L (2009)
-
Tighten to 16 Nm {1.6 kgf-m, 142 in-lbf}.
6. Continue bleeding the rest of the system, going in order from the LR bleeder screw to the RF bleeder screw, ending with the LF bleeder screw.
-
Tighten to 16 Nm {1.6 kgf-m, 142 in-lbf}.
7. Close the bleeder tank valve. Remove the tank hose from the adapter and remove the adapter. Fill the reservoir with clean, specified brake fluid
and install the reservoir cap.
Anti-Lock Brake System (ABS) Bleeding
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal
injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
WARNING:Do not allow the brake master cylinder to run dry during the bleeding operation. Master cylinder may be damaged if operated without fluid,
resulting in degraded braking performance. Failure to follow this instruction may result in serious personal injury.
NOTE:Bleeding the hydraulic control unit (HCU) is required only when removing or installing the HCU, master cylinder, or opening the tubes and
hoses to the HCU.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash the surface with water.
NOTE:Pressure bleeding the brake system is preferred to manual bleeding.
1. For all vehicles, follow the Pressure Bleeding or Manual Bleeding procedure steps to bleed the system.
2. Connect the scan tool, access the SYSTEM BLEED FUNCTION and follow the directions on the scan tool.
3. Access the SYSTEM BLEED FUNCTION and follow the directions on the scan tool.
4. Repeat the Pressure Bleeding or Manual Bleeding procedure steps to bleed the system.
5. For Hybrid vehicles, follow the scan tool instructions and carry out the Multi-Calibration Routine.
