Tribute 2WD L4-2.5L (2009)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed (TSS) Sensor Removal/Installation
TURBINE SHAFT SPEED (TSS) SENSOR REMOVAL/INSTALLATION
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Disconnect the turbine shaft speed (TSS) sensor electrical connector, remove the bolt and the TSS sensor.
3. To install, reverse the removal procedure.
-
Tighten to 12 Nm {1.2 kgf-m, 106 in-lbf}.
-
Fill with clean transaxle fluid to the correct level.