Tribute 2WD L4-2.5L (2009)
6. For air bag modules with multiple loops, twist together a wire from each loop then repeat for the remaining wires from each loop.
NOTE:Typical driver air bag module with 2 loops shown, other air bag modules with multiple loops similar.
7. Make a jumper harness to deploy the air bag module.
-
Obtain 2 wires (20 gauge minimum) at least 9.14 m (30 ft) long and strip both ends of each wire.
-
At one end of the jumper harness, connect the wires together.
8. Using the end of the jumper harness that the wires are not connected together, attach each wire of the jumper harness to each wire of the air bag
module or to the twisted-together wires if multiple loops. Use tape or other insulating material to make sure that the leads do not make contact with
each other.
Driver air bag modules