Tribute 2WD L4-2.5L (2009)
Seat Position Sensor: Service and Repair
SEAT POSITION SENSOR REMOVAL/INSTALLATION
WARNING:To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
NOTE:The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not
indicate a SRS fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Raise the driver seat and then position it to the middle of the track.
2. Depower the system. See See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And
Repowering.
3. Remove the driver seat. See See: Body and Frame/Seats/Description and Operation/Seats.
4. Disconnect the seat position sensor electrical connector.
