Tribute 2WD L4-2.5L (2009)
Trunk / Liftgate Switch: Service and Repair
Liftgate Release Switch - Liftgate Glass Removal/Installation
-
LIFTGATE RELEASE SWITCH - LIFTGATE GLASS REMOVAL/INSTALLATION
1. Remove the liftgate trim panel. See .
2. Remove the 4 liftgate trim bezel nuts and remove the bezel from the liftgate.
-
Disconnect the liftgate glass release electrical connector.
-
Using an appropriate tool, press the tabs and remove the liftgate glass release switch.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
3. To install, reverse the removal procedure.
