Tribute 2WD L4-2.5L (2009)
7. Remove the starter motor positive cable nut.
-
To install, tighten to 12 Nm {1.2 kgf-m, 106 in-lbf}.
8. Remove the starter solenoid wire nut.
-
To install, tighten to 5 Nm {0.5 kgf-m, 44 in-lbf}.
9. Position the starter motor terminals aside.
10. Remove the battery ground cable bolt.
-
To install, tighten to 25 Nm {2.5 kgf-m, 18 ft-lbf}.
11. Position the battery ground cable aside.
12. Disconnect the pin-type retainer from the left rear of the engine.
13. Disconnect the pin-type retainer from the middle of the intake runners.
14. Disconnect the pin-type retainer from the front of the engine.
15. Disconnect the clip retainer from the right front of the engine.
16. Disconnect the clip retainer from the left front of the engine.
17. Remove the body ground terminal bolt from the left fenderwell.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
18. Open the battery junction box (BJB) cover and remove the BJB terminal nut.
-
To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
19. Position the BJB terminal aside.
20. Disconnect the BJB electrical connector.
21. Disconnect the retainers fastening the battery cables to the battery tray.
22. Remove the battery cables.
23. To install, reverse the removal procedure.
