Tribute 2WD L4-2.5L (2009)
1. Using the special tools, install a new wheel bearing into the wheel knuckle.
2. Install the new wheel bearing snap ring.
3. Using the special tools, install the wheel hub into the wheel bearing.
4. Install the wheel speed sensor ring.
5. Install the brake drum. See See: Brakes and Traction Control/Drum Brake System/Backing Plate/Service and Repair/Brake Drum
Removal/Installation.
6. Install the new wheel hub nut.
-
Tighten to 290 Nm {29 kgf-m, 214 ft-lbf}.
NOTE:Apply the brake to keep the halfshaft from rotating.