Tribute 2WD L4-2.5L (2009)
14. Connect the transaxle electrical wiring harness retainers to the transmission fluid pan stud bolts.
15. Install the ACL assembly.
a. Install the ACL assembly bracket bolt.
i.
Tighten to 11 Nm {1.1 kgf-m, 97 in-lbf}.
b. Connect the MAF sensor electrical connector.
c. Connect the brake booster vacuum hose to the ACL outlet pipe.
d. Attach the wiring harness fastener to the ACL assembly.
e. Connect the engine breather to the ACL assembly.
f.
Tighten the ACL outlet pipe clamp at the TB.
i.
Tighten to 5 Nm {0.5 kgf-m, 44 in-lbf}.
16. Fill with clean transaxle fluid to the correct level.
