Tribute 2WD L4-2.5L (2009)
Drive/Propeller Shaft: Service and Repair
DRIVESHAFT REMOVAL/INSTALLATION
NOTE:The Hybrid driveshaft is longer than the driveshaft in the non-Hybrid and is not interchangeable.
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Remove the ground strap bolt.
-
To install, tighten to 40 Nm {4.1 kgf-m, 30 ft-lbf}.
3. Remove and discard the 6 front driveshaft-to-transfer case bolts and washers.
-
To install, tighten to 40 Nm {4.1 kgf-m, 30 ft-lbf}.