Tribute 2WD L4-2.5L (2009)
Removal
1. Disconnect the gearshift cables from the transaxle gearshift control assembly.
-
Pull the spring clip out of the groove, lift upward and rotate the clip 90 degrees.
NOTE:Carefully disconnect the spring clip from the cable end. It can become unfastened from the cable.
2. Disconnect the gearshift cables from the transaxle bracket.
NOTE:Carefully pry the gearshift cables from the transaxle bracket.
3. Remove the floor console. See See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair.
4. Remove the restraints control module (RCM). See See: Relays and Modules/Relays and Modules - Restraint Systems/Air Bag Control
Module/Service and Repair/Restraints Control Module (RCM) Removal/Installation.
5. Disconnect the smart junction box (SJB) electrical connector and the 2 harness electrical connectors.