Tribute 2WD L4-2.5L (2009)
3. Install the 2 gearshift cable clips.
CAUTION:Make sure the clips are set completely within the cable adapter groove and fully seated.
4. Install the 4 gearshift lever nuts.
-
Tighten to 25 Nm {2.5 kgf-m, 18 ft-lbf}.
5. Adjust the gearshift cables. See See: Shift Linkage/Shift Cable/Adjustments.
6. Install the floor console finish panel.
7. Install the gearshift lever knob and boot assembly.