Tribute 2WD L4-2.5L (2009)
Windshield Washer Hose: Service and Repair
WASHER HOSE REPAIR
NOTE:This procedure may be carried out on rubber hoses only. If a plastic washer hose is leaking, a new washer hose must be installed.
1. Locate and verify the leaking washer hose.
2. Cut the hose cleanly and remove the damaged portion of the washer hose.
3. Install a windshield washer hose adapter between the cut ends of the hose.
4. Install a segment of 6.4 mm (0.25 in) i.d. black rubber hose over the ends of the washer hose, and clamp both ends of the rubber hose using spring
clamps.
NOTE:In difficult cases, clamping may be required.