Tribute 2WD V6-3.0L (2008)
Front Bumper Cover / Fascia: Service and Repair
FRONT BUMPER COVER REMOVAL/INSTALLATION
CAUTION: Prior to removal of the front bumper cover, place tape at the corners of the bumper cover and below the headlamps to prevent
damage to the paint.
1. Raise and support the vehicle.
2. Remove the 6 rivets from inside the front splash shield {3 each side}.
3. Remove the 4 fender splash shield-to-air deflector bolts {2 each side}.
-
To install, tighten to 5 N.m {0.5 kgf.m, 44 in.lbf}.
4. Remove the 3 air deflector bolts.
-
To install, tighten to 5 N.m {0.5 kgf.m, 44 in.lbf}.
5. Remove the 2 front bumper cover center rivets from the front bumper cover.
6. Disconnect the fog lamp electrical connectors, if equipped.
