Tribute 2WD V6-3.0L (2008)
All Vehicles
1. Disconnect the battery ground cable.
2. Remove the air cleaner and the air cleaner outlet pipe.
3. Disconnect the master cylinder brake tube fittings from the hydraulic control unit (HCU).
^
To install, tighten to 23 N-m (2.3 kgf-m, 17 ft-lbf).
Vehicles With 3.0L (4V) Engine
4. Disconnect the master cylinder brake tube fittings from the master cylinder and remove the brake tubes.
^
To install, tighten to 23 N-m (2.3 kgf-m, 17 ft-lbf).
All Vehicles
5. Disconnect the front brake tube fittings from the HCU.
^
To install, tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
6. Disconnect the rear brake tube fittings from the jumper tubes.
^
To install, tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
7. Disconnect the electrical connector by rotating the protective cover.
8. Remove the 3 HCU bracket-to-frame bolts and remove the HCU.
^
To install, tighten to 23 N-m (2.3 kgf-m, 17 ft-lbf).
9. To install, reverse the removal procedure.
^
Bleed the brake system.
