Tribute 2WD V6-3.0L (2008)
Hose/Line HVAC: Service and Repair
Evaporator Outlet Line - 2.3L and 3.0L (4V) Removal/Installation
EVAPORATOR OUTLET LINE - 2.3L AND 3.0L (4V) REMOVAL/INSTALLATION
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Recover the refrigerant. See DISCHARGING AND RECOVERY.
3. Remove the RH lower engine splash shield.
4. Remove the A/C compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 N.m (1.5 kgf.m, 11 ft.lbf).
