Tribute 2WD V6-3.0L (2008)
Note
^
Make sure the sensor is fully seated into the cradle. The sensor will make a "click" noise when correctly seated.
2. Insert a new locking clip into the sensor.
Note
^
The locking clip can only be fully seated when installed in the correct orientation. If the sensor locking clip cannot be fully inserted, then the
sensor may not be fully seated on the cradle or the locking clip may be inserted backward.
3. Install the tire onto the wheel.
Caution
^
The sensor, cradle and strap can be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
4. Train the tire pressure sensor(s). See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING. See: Procedures
Note
^
A new tire pressure sensor is shipped in an OFF mode (or battery saver mode) and must be turned ON before it can be trained. To turn the
sensor ON, inflate the tire to the recommended inflation pressure and wait at least 2 minutes, then continue with the sensor training procedure.
Tire Pressure Monitoring System (TPMS) Strap and Cradle
TIRE PRESSURE MONITORING SYSTEM (TPMS) STRAP AND CRADLE DISASSEMBLY/ ASSEMBLY
