Tribute 2WD V6-3.0L DOHC (2003)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (HO2S)
HEATED OXYGEN SENSOR (HO2S) 3.0L DURATEC (4V), LH
Removal and Installation
1. Raise and support the vehicle. Refer to LIFTING.
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
NOTE: If necessary, lubricate the HO2S with Penetrating and Lock Lubricant to aid in removal.
3. Using the special tool, remove the HO2S.
NOTE: Apply a light coat of High Temperature Nickel Anti-Seize Lubricant to the threads of the HO2S to aid in installation.
4. To install, reverse the removal procedure.
HEATED OXYGEN SENSOR (HO2S) - 3.0L DURATEC (4V), RH
Removal and Installation
1. Disconnect the heated oxygen sensor (HO2S) electrical connector.
2. Raise and support the vehicle. Refer to LIFTING.