Tribute 4WD L4-2.3L (2005)
Drive/Propeller Shaft: Testing and Inspection
Driveshaft Indexing
DRIVESHAFT INDEXING
Note: If indexing the driveshaft does not eliminate the vibration, balance the driveshaft. See Driveshaft Runout and Balancing. See: Driveshaft
Runout and Balance
1. Raise and support the vehicle.
Caution: Do not reuse the CV joint bolts and washers. Install new bolts and washers only or damage to the vehicle may occur.
2. Remove the six front driveshaft to power take off bolts and washers.
^
Discard the bolts and washers.
3. Rotate the flange 60 degrees.
4. Connect the front driveshaft and install the new bolts and washers.
Caution: Do not reuse the bolts and straps for the pinion yoke. Install new bolts and straps or damage to the vehicle may occur.