Tribute 4WD L4-2.3L Hybrid (2008)
2. Install the OCS system components to the seat cushion pan.
a. Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
i.
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
b. Slide the OCSM into the seat cushion frame bracket.
i.
The OCSM must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the RCM.
c. Install the rivets.
NOTE: When installing a service part OCS, the seat wire harness pressure sensor electrical connector is not used.
NOTE: Make sure the pressure sensor hose is not kinked during installation.
3. Attach the seat cushion trim cover retainers to the seat cushion frame.
4. Position the seat track to the seat cushion to the seat track.
CAUTION: While positioning the seat cushion frame and occupant classification sensor (OCS), be careful not to damage any of the components.
Failure to do so can result in component failure.
5. Install the 4 seat track bolts.
-
Tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
6. Connect the seat wire harness OCS system electrical connector to the service part OCS system electrical connector.
