Tribute 4WD L4-2.3L Hybrid (2008)
Oil Pressure Sender: Service and Repair
-
ENGINE OIL PRESSURE (EOP) SWITCH REMOVAL/INSTALLATION - HYBRID
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Remove the pin-type retainer, the 5 bolts and the RH splash shield.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
3. Disconnect the engine oil pressure (EOP) switch electrical connector.
4. Remove the EOP switch.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
5. To install, reverse the removal procedure.
-
Apply thread sealant with PTFE to the EOP switch threads.