Tribute 4WD L4-2.3L Hybrid (2008)
Water Pump: Service and Repair
Water Pump Removal/Installation
-
WATER PUMP REMOVAL/INSTALLATION - HYBRID
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Drain the cooling system. See - See: Cooling System/Coolant/Service and Repair/Removal and Replacement.
3. Remove the accessory drive belt. See - See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
4. Remove the 3 bolts and the water pump pulley.
-
To install, tighten to 20 Nm {2.0 kgf-m, 15 ft-lbf}.
5. Remove the 3 bolts and the water pump.