Tribute 4WD L4-2.3L Hybrid (2008)
3. Remove the motor electronics cooler. See - See: Engine, Cooling and Exhaust/Cooling System/Radiator/Service and Repair/Motor Electronics
Cooler Removal/Installation.
4. Remove the 4 radiator bracket bolts.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
5. Detach and remove the RH and LH radiator brackets.
6. Remove the condenser outlet and inlet fitting nuts and disconnect the fittings.
-
Discard the O-ring seals.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
7. Remove the 2 condenser bolts.
-
To install, tighten to 7 Nm {0.7 kgf-m, 62 in-lbf}.
8. Remove the condenser core.
9. To install, reverse the removal procedure.
-
Install new gasket seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil. See See: Service and Repair/Refrigerant Oil Adding.
10. Evacuate, leak test and charge the refrigerant system. See See: Service and Repair/Air Conditioning (A/C) System Evacuation And Charging.