Tribute 4WD L4-2.3L Hybrid (2008)
Hose/Line HVAC: Service and Repair
Evaporator Inlet Line Removal/Installation
-
EVAPORATOR INLET LINE REMOVAL/INSTALLATION - HYBRID
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant. See See: Heating and Air Conditioning/Service and Repair/Discharging And Recovery.
2. Remove the evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
3. Remove the auxiliary evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.