Tribute 4WD L4-2.3L Hybrid (2008)
Accelerator Pedal: Service and Repair
-
ACCELERATOR PEDAL AND BRACKET REMOVAL/INSTALLATION - HYBRID
1. Disconnect the accelerator pedal electrical connector.
2. Remove the 3 bolts and release the accelerator pedal from the locating/retaining tabs on the lower RH corner of the accelerator pedal mounting
bracket.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
3. Remove the accelerator pedal bracket bolt.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
NOTE: If installing a new accelerator pedal and sensor assembly, the accelerator pedal bracket may also require replacement due to a different mounting
bolt pattern between the original and replacement service parts.
4. Remove the 2 bolts and remove the accelerator pedal bracket.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
5. To install, reverse the removal procedure.
CAUTION: Verify that the accelerator pedal is engaged into the locating/retaining tabs of the accelerator pedal bracket during installation, prior to
installing the bolts. Failure to follow this instruction may result in damage to the accelerator pedal or accelerator pedal bracket.
