Tribute 4WD L4-2.3L Hybrid (2008)
5. Remove the passenger air bag module.
a. Disconnect the 2 passenger air bag module electrical connectors.
b. Detach the wire harness routing clip and remove the passenger air bag module.
CAUTION: During passenger air bag module installation, make sure the passenger air bag module wire harness routing clip is attached to the passenger
air bag module. Failure to follow this instruction may result in wiring harness damage.
CAUTION: The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag module.
Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into the passenger air bag
module. Failure to follow these instructions may result in component and/or connector damage.
6. To install, reverse the removal procedure.
7. Repower the system. See See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And
Repowering.
