Tribute 4WD L4-2.5L Hybrid (2009)
-
Remove the 6 front driveshaft-to-transfer case bolts and washers. Discard the bolts and washers.
-
To install, tighten to 37 Nm {3.7 kgf-m, 27 ft-lbf}.
-
Remove the 4 universal joint cap strap bolts and 2 cap straps and remove the front driveshaft. Discard the universal joint cap strap bolts and
cap straps.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
3. Remove the 4 bolts {2 each side} and the lateral support crossmember.
-
To install, tighten to 115 Nm {11.7 kgf-m, 85 ft-lbf}.
4. Remove the muffler inlet pipe on the 2.5L engine. See See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair.
5. Remove the 6 bolts and the scrivet from the LH splash shield and remove the splash shield.