Tribute 4WD L4-2.5L Hybrid (2009)
8. Release the side air bag module deployment chute J-clip from around the side air bag module.
9. Pull the side air bag module deployment chute and J-clips through the opening in the backrest foam pad.
WARNING:Check the seat side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any damage to the
deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to follow these instructions may result in the seat
side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a crash.
10. Invert and remove the backrest trim cover.
11. To install, reverse the removal procedure.
12. Repower the supplemental restraint system (SRS). See See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and
Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And Repowering.
Front Seat Backrest Removal/Installation
FRONT SEAT BACKREST REMOVAL/INSTALLATION
WARNING:Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:If a side air bag deployment took place, a new seat back pad, trim cover and side air bag module and nuts must be installed. The seat back frame
should be replaced if necessary.
NOTE:The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is
normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat. See See: Service and Repair.