Tribute 4WD L4-2.5L Hybrid (2009)
Seat Track: Service and Repair
SEAT TRACK REMOVAL/INSTALLATION
WARNING:Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this
instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious
personal injury or death.
WARNING:Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is
normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat. See See: Service and Repair.
2. Remove the front seat backrest. See See: Seat Back/Service and Repair/Removal and Replacement/Front Seat Backrest Removal/Installation.
3. Remove the safety belt buckle pretensioner.
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
4. Disconnect the electrical connectors, detach the wiring harness from the seat track.
-
For the driver seat, disconnect the seat position sensor electrical connector.
-
If equipped, disconnect the power seat motor electrical connector.
-
Detach the seat harness electrical connector from the seat track.
NOTE:Note wiring harness routing for installation.
5. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
6. To install, reverse the removal procedure.
-
Transfer components as necessary.