Tribute 4WD L4-2.5L Hybrid (2009)
1. Remove the bleeder screw cap and place a box-end wrench on the bleeder screw. Attach a rubber drain hose to the bleeder screw and submerge the
free end of the hose in a container partially filled with clean, specified brake fluid.
2. Have an assistant pump the brake pedal at least 2 times and then hold firm pressure on the brake pedal.
3. Loosen the bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the bleeder
screw.
-
Repeat until clear, bubble-free fluid comes out.
-
Refill the brake master cylinder reservoir as necessary.
4. Tighten the bleeder screw to specifications. Remove the rubber hose and install the bleeder screw cap.
-
Tighten to 16 Nm {1.6 kgf-m, 142 in-lbf}.
5. Apply brakes several times to verify correct brake operation.
Wheel Cylinder
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal
injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
WARNING:Do not allow the brake master cylinder to run dry during the bleeding operation. Master cylinder may be damaged if operated without fluid,
resulting in degraded braking performance. Failure to follow this instruction may result in serious personal injury.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash the surface with water.
