Tribute 4WD L4-2.5L Hybrid (2009)
Brake Caliper: Service and Repair
Brake Caliper - Removal/Installation
-
BRAKE CALIPER REMOVAL/INSTALLATION - HYBRID
Removal
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal
injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION, seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash it with water.
CAUTION:Do not allow brake fluid to overflow the master cylinder reservoir. Brake fluid may damage the high-voltage components.
NOTE:The rear brake pads will wear at approximately twice the rate of the front brake pads.
1. Remove the wheel and tire assembly. See See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
2. For the LH brake caliper, release the lower portion of the brake pad anti-rattle spring.
-
Apply force to the center of the spring and pull outward at the bottom of the spring to remove it from the lower brake caliper cavity.
CAUTION:If the anchor housing spring is to be removed, do not force the spring off the brake caliper or damage to the spring can occur.
CAUTION:Do not use any tools to remove the spring, use hand force only. Do not use excessive force or damage to the spring can occur.
NOTE:The LH side brake pad anti-rattle spring must be installed with the 2-tabbed end in the upper brake caliper cavity.