Tribute 4WD L4-2.5L Hybrid (2009)
NOTE:Mark the hood latch position prior to removal of the bolts.
6. Remove the center support lower bolt.
-
To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
7. Remove the bolt and the center support.
-
To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
8. Remove the 2 cooling fan bolts and the cooling fan motor and shroud.
-
To install, tighten to 7 Nm {0.7 kgf-m, 62 in-lbf}.
9. Disconnect the cooling fan resistor electrical connector.
10. Disconnect the 2 cooling fan electrical connectors.
11. Remove the 6 cooling fan bolts.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
12. Remove the LH and the RH cooling fans.
NOTE:Remove the LH cooling fan first and slide the RH cooling fan to the left side to remove.
13. To install, reverse the removal procedure.