Tribute 4WD L4-2.5L Hybrid (2009)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - LH Removal/Installation
-
TEMPERATURE BLEND DOOR ACTUATOR - LH REMOVAL/INSTALLATION (HYBRID ONLY)
NOTE:The LH temperature blend door actuator is present on dual-zone dual automatic temperature control (DATC) vehicles to control the LH
temperature blend door only.
1. Disconnect the LH temperature blend door actuator electrical connector.
2. Remove the 2 LH temperature blend door actuator screws.
-
To install, tighten to 3 Nm {0.3 kgf-m, 27 in-lbf}.
3. Remove the LH temperature blend door actuator.
4. To install, reverse the removal procedure.