Tribute 4WD L4-2.5L Hybrid (2009)
-
When replacing a fuse, be sure to replace it with one of the same capacity. If a fuse fails again, the circuit probably has a short and the wiring
should be inspected.
-
Be sure the negative battery terminal is disconnected before replacing a main fuse.
-
When replacing a pullout fuse, use the fuse puller.
ELECTRICAL TROUBLESHOOTING TOOLS
Jumper Wire
-
A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to by pass a switch.
CAUTION: Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to
wiring harnesses or electronic components.
Voltmeter
-
The DC voltmeter is used to measure circuit voltage. A voltmeter with a range of 15 V or more is used by connecting the positive (+) probe (red