Tribute 4WD L4-2.5L Hybrid (2009)
5. Remove the fill plug on the side of the transaxle.
6. Install the drain plug.
-
Tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
-
After the transaxle fluid has been drained, clean the drain plug threads and apply a small amount of pipe sealant to the threads.
7. Fill the transaxle with clean automatic transaxle fluid as specified until the level reaches the bottom of the fill plug hole.
8. Install the fill plug.
-
Tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
NOTE:Clean the area around the fill plug removing transaxle fluid that may have spilled on the transaxle case.
9. Install the LH splash shield and the retainers.