Tribute 4WD L4-2.5L Hybrid (2009)
CAUTION:Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related
component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the evaporative emission (EVAP) canister assembly. See See: Service and Repair.
2. Disconnect the EVAP canister vent solenoid electrical connector, release the pin-type retainer and remove the EVAP canister wire harness.
3. Remove the 3 EVAP canister tray bolts.
-
To install, tighten to 5 Nm (0.5 kgf-m, 44 in-lbf}.
4. Disconnect the EVAP canister purge tube-to- EVAP canister quick connect coupling.
5. Disconnect the EVAP canister fuel vapor tube-to-EVAP canister quick connect coupling.
6. Remove the EVAP canister from the tray.
7. Depress the locking tab outward, rotate the EVAP canister vent solenoid clockwise and remove it from the EVAP canister.
-
Apply clean engine oil to the EVAP
8. To install, reverse the removal procedure.
-
Carry out the evaporative emissions system leak test. See See: Testing and Inspection/Component Tests and General Diagnostics.
-
Carry out the evaporative emissions repair verification drive cycle. See See: Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes/Evaporative Emission Repair Verification Drive Cycle.
