Tribute 4WD L4-2.5L Hybrid (2009)
1. Rotate the lock tab and install the quick connect coupling onto the fitting.
NOTE:Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
2. Release the lock tab into the latched position.
NOTE:Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
3. Connect the battery ground cable. See See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Disconnect.
Disconnect - Type III
WARNING:Do not smoke, or carry lighted tobacco or have an open flame of any type when working on or near any fuel-related components. Highly
flammable vapors are always present and can ignite. Failure to follow these instructions may result in serious personal injury.
WARNING:Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious
personal injury.
WARNING:Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental
spraying of fuel. Fuel in the fuel system remains under pressure, even when the engine is not running. Failure to follow this instruction may result in
serious personal injury.
WARNING:Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related
component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
CAUTION:When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector retaining