Tribute 4WD L4-2.5L Hybrid (2009)
Tire Pressure Module: Service and Repair
TIRE PRESSURE MONITORING SYSTEM MODULE REMOVAL/INSTALLATION
CAUTION:Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE:The tire pressure monitoring system (TPMS) is integral to the smart junction box (SJB) and is not serviced separately.
NOTE:A new SJB module is delivered in manufacturing mode with pre-set diagnostic trouble codes (DTCs). These DTCs require that a particular set of
operations to be carried out in order to clear them and enable the module for normal operations. The pre-set DTCs are as follows: B2477 - Module
Configuration Failure/MismatchB2868 - Left Front Tire Pressure Sensor FaultB2869 - Right Front Tire Pressure Sensor FaultB2870 - Left Rear Tire
Pressure Sensor FaultB2871 - Right Rear Tire Pressure Sensor FaultC2780 - ECU in Manufacturing Mode
NOTE:A reconfigured SJB may also set the above codes and will need to go through the same set of procedures as a new module to enable normal
operation.
NOTE:The steps included in the SJB removal and installation process are critical to tire pressure monitoring system (TPMS) operations and will permit
a new or reconfigured module to operate as intended. Each step is designed to carry out a particular operation and clear the manufacturing mode DTCs.
Once these DTCs are cleared, the new or reconfigured module will enter into normal operating mode.
1. Remove the SJB. See See: Relays and Modules - Powertrain Management/Relays and Modules - Computers and Control Systems/Body Control
Module/Service and Repair/Smart Junction Box (SJB) Removal/Installation.
