Tribute 4WD L4-2.5L Hybrid (2009)
NOTE:The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the system. See See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And
Repowering.
2. Open and lower the glove compartment door.
3. Remove the 2 passenger air bag module bolts.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
4. Through the glove compartment opening, release the passenger air bag module deployment door clips while pushing the passenger air bag module
out of the I/P.
CAUTION:Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow these instructions may result in
component damage and/or system failure.
NOTE:During passenger air bag module installation, make sure all the deployment door clips are fully seated into the instrument panel.
NOTE:Use care when removing the passenger air bag module from the instrument panel (I/P). The passenger air bag module can drop down during
removal and the passenger air bag module rear bracket can scratch the front of the I/P.
5. Remove the passenger air bag module.
a. Disconnect the 2 passenger air bag module electrical connectors.