Tribute 4WD L4-2.5L Hybrid (2009)
Manifold Pressure/Vacuum Sensor: Service and Repair
-
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION - 2.5L
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Disconnect the MAP electrical connector.
3. Using a tool like KD Tool #58181 or Lisle T25 Torx Bit, remove the screw and the MAP sensor.
-
To install, tighten to 3 Nm (0.3 kgf-m, 27 in-lbf).
4. To install, reverse the removal procedure.
NOTE:Lubricate the MAP sensor O-ring seal with clean engine oil.
