Tribute 4WD L4-2.5L Hybrid (2009)
1. Bend the retaining tab back on the pressure sensor component bracket.
2. Feed the OCS components (pressure sensor and hose) through the seat cushion pan opening.
WARNING:Inspect the occupant classification sensor bladder, seat cushion pan and support assembly for any foreign objects, before installing the
occupant classification sensor to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the
event of an air bag deployment.
CAUTION:Failure to route the seat occupant classification sensor components through the correct seat cushion support opening can cause component
failure.
CAUTION:While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components. Failure
to do so can result in component failure.
3. Align the OCS bladder to the seat cushion pan.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion pan.
5. Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
NOTE:Make sure the pressure sensor hose is not kinked during installation.
6. Slide the OCS ECU into the seat cushion pan bracket and install the rivets.
-
The OCS ECU must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the restraints control module
