Tribute 4WD L4-2.5L Hybrid (2009)
1. Depower the system. See See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and
Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And Repowering.
2. Remove the passenger seat. See See: Body and Frame/Seats/Service and Repair.
NOTE:The seat wiring harness will be reused.
3. Disconnect the electrical connectors and wiring clips.
a. Disconnect the OCS ECU electrical connector.
b. Disconnect the pressure sensor electrical connector.
c. Release the two wiring clips on the wiring harness from the cushion pan.
i.
If equipped with heated seats, disconnect the heated seat module electrical connector, release the wiring clip on the wiring harness from the
cushion pan, and disconnect the 2 cushion element electrical connectors.
4. Remove the 4 seat track-to-cushion frame bolts.
5. Remove the seat cushion and pan assembly.
-
To aid in removal, recline the seat.
CAUTION:While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components. Failure
to do so can result in component failure.
