Tribute 4WD V6-3.0L DOHC (2003)
2. Tighten the right-hand side RCM bolts.
3. Reposition the carpet back at the right-hand side of the center tunnel area under the instrument panel.
WARNING: The tightening torque of the restraints control module (RCM) retaining bolts is critical for proper system operation.
4. Connect the RCM.
1. Tighten the bolt.
2. Connect the RCM electrical connectors.
3. Slide and engage the RCM electrical connector locking clips.
5. Reposition the carpet back at the left-hand side of the center tunnel area under the instrument panel.
6. Connect the battery ground cable. For additional information, refer to BATTERY DISCONNECT
7. With the restraint system diagnostic tools still installed at all deployable devices, prove out the air bag system. For additional information, refer to
DIAGNOSTIC INSTRUCTIONS - AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL RESTRAINT SYSTEM (SRS), in
this section.
8. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY DISCONNECT.
WARNING: The restraint system diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
9. Remove the air bag from the driver seat safety belt buckle pretensioner floor electrical connector.
10. Connect the driver seat safety belt buckle pretensioner electrical connector.
Vehicles with side air bags
WARNING: The restraint system diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
11. Remove the air bag from the driver seat side air bag floor electrical connector.
12. Connect the driver seat side air bag electrical connector.
All vehicles
WARNING: The restraint system diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
13. Remove the air bag from the passenger seat safety belt buckle pretensioner floor electrical connector.
14. Connect the passenger seat safety belt buckle pretensioner electrical connector.
Vehicles with side air bags