Tribute DX 4WD V6-3.0L DOHC (2002)
2. Install the screw.
3. Install the seat backrest handle.
9. If equipped, install the seat height adjustment control.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
In damaged components.
10. Install the driver seat.
1. Position the driver seat.
1. If equipped with power seats, connect the electrical connector.
2. Install the seat track to floor bolts
11. If equipped with power seats, connect the battery ground cable. For additional information, refer to BATTERY DISCONNECT.
12. Position the driver seat forward.
13. Install the seat track to floor nuts.
14. If equipped with power seats, disconnect the battery ground cable and wait one minute. For additional information, refer to BATTERY
DISCONNECT.
Vehicles with side air bag
