Tribute DX 4WD V6-3.0L DOHC (2002)
Seat Belt Height Adjuster: Service and Repair
Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts
SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS
1. Remove the B-pillar trim panel
2. Use the half-inch drill to drill out the damaged threads in the upper B-pillar structure.
NOTE: After each rotation, back tap off slightly to remove new cuffings and be sure to clean out any chips before proceeding.
3. Apply a suitable lubricant to the M14x1.5 tap and tap new threads.
4. Use a threaded insert and screw it into the retapped hole until it is slightly below the surface of the hole.
NOTE: If the two hex-head bolts on the front seat shoulder strap adjuster are not stripped, refer to SAFETY BELT SHOULDER HEIGHT
ADJUSTER to install the height adjuster to the body. If the front seat shoulder strap adjuster bolts are stripped, replace the adjuster; for additional
information, refer to SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS.
5. Use a hammer to lightly tap the installation tool several times to drive down the insert keys.