Tribute DX 4WD V6-3.0L DOHC (2002)
Drive/Propeller Shaft: Service and Repair
Removal and Installation
Removal and Installation
Warning: The normal operating temperature of the exhaust system is very high. Never attempt to remove any part of the system until it has
cooled. Be especially careful when working around the catalytic converters. The temperature of the converter rises to a high level after only a
few minutes of engine operation. Failure to follow these instructions may result in personal injury.
1. Place the selector lever in NEUTRAL.
2. Raise and support the vehicle.
3. Remove the ground strap bolt
Caution: Do not reuse rear driveshaft joint bolts. Install new bolts only or damage to the vehicle may occur.
4. Remove the rear driveshaft universal joint caps.
1. Index-mark the pinion and yoke to the rear of the driveshaft.
2. Remove and discard the bolts and straps.
Caution: Do not reuse the CV joint bolts and washers. Install new bolts and washers only or damage to the vehicle may occur.
5. Remove the six front driveshaft to power take off bolts and washers.
-
Discard the bolts and washers.
Caution: Do not reuse center bearing nuts. Install new nuts only or damage to the vehicle will occur.
